CRU ToughTech Secure 128 mini-Q with WriteLock User Manual
Page 4
CRU
U s e r M a n u a l f o r T o u g h T e c h m i n i Q m o d e l s ( A 9 - 0 0 0 - 0 0 0 1 r e v 1 . 5 )
- 4 -
2.1.3 One drive screw may already be inserted into the circuit board to prevent movement during
shipment. You’ll need to remove this screw before you can install the hard drive. The screw is held in
place by a plastic nut.
2.1.4
You are now ready to install your 2.5” SATA drive. Line up the drive’s interface with the SATA
interface on the circuit board.
2.1.5
You may need to angle the drive as you push it into place. After connecting the drive to the SATA
interface on the circuit board, the drive should lay flat on the board.
2.1.6 Secure the drive in place using the included screws. Drive the screws through the bottom of the
circuit board and into the hard drive.