Datapath RSN870 - Manual (Page 10)

10
Fig.9
Error
The render station was previously connected without any errors but is now not responding. It will revert to
a connected state once the connection is restored.
Reboot
The Reboot button allows the user to remotely reboot a connected render station. It can also be used to
reset the connection to a render station that is in an error state.
This is intended as an administrative
tool and should only be used under the direction of support staff.
Configuring Cameras
By default Wall Control-red does not have any cameras configured. You may add cameras by clicking the
Add button on the right side of the dialog.
Adding New IP-Cameras
Click on the Add button and the following dialog is displayed.
Fig.10