Doremi ShowVault / IMB - Manual (Page 3)

IMB.DP.003389.DRM
Page 3 of 16 Version 1.2
Doremi Labs
1 Introduction
This document describes the necessary steps to install and configure the two IMBs for a dual
projector setup. It also describes how to create a basic playlist.
In Dual IMB setup (using a single ShowVault and two IMBs for dual projector), the two IMBs are not
identical in terms of firmware and software configuration and in terms of serialization.
The primary IMB, a.k.a. the IMB SM (Security Manager) connected to the ShowVault via PCI-E, is
similar to a regular IMB in terms of serialization. It uses a specific firmware for Dual IMB setup in the
32.xx version range. It can be updated back and forth, with regular IMB firmware used as a regular
IMB.
The secondary IMB, a.k.a IMB LD (Link Decryptor), which is not connected to the ShowVault via PCI-
E, has the same hardware as a regular IMB but is serialized differently in factory. This different
serialization is what allows it to behave as a secondary IMB, a Link Decryptor IMB. It uses a specific
firmware for Dual IMB setup in the 33.xx version range. It cannot be updated back to regular IMB
firmware and cannot be used as a regular/primary IMB.
In this document, the Primary IMB will be referred to as the SM (Security Manager), and the
secondary as the LD (Link Decryptor).
Note: Dolby 3D is not yet supported in Dual IMB setups.
1.1 Contact Information
If in need of help or assistance, please contact Doremi Labs Technical Services:
USA
24/7 Technical Services line: + 1-866-484-4004
Technical Services Email: [email protected]
Europe
24/7 Technical Services line: + 33 (0) 492-952-847
Technical Services Link: http://support.doremitechno.org/ticketing
Japan
Technical Services line: + 044-966-4855
Technical Services Email: [email protected]
Australia ~ China ~ India ~ Indonesia ~ Korea ~ Malaysia ~ New Zealand ~ Philippines ~
Singapore ~ Taiwan ~ Thailand
Technical Services Email: [email protected]