KBC Networks ESML6-P3 - Manual (Page 12)

Ethernet Switch User Manual
Inst_manual_hw-ESML6-P3-Rev_1010A
Copyright © KBC Networks Ltd.
Page 12 of 17 www.kbcnetworks.com
3.3 Fiber Port Testing
As shown in Figure 3.2, connect two ESML6-P3 units via their fiber ports. Then
attach a computer to any RJ45 port on each device and send the “ping” command
between the connected computers. If both computers get the command without
packet loss and the corresponding LINK/ACT indicators of the fiber ports flash, this
then shows the fiber ports under test are functioning correctly.
Figure 3.2 Fiber Port Testing
4 System Example
Figure 4.1 ESML6-P3 Typical System Application