KLING & FREITAG K&F Line 212-9 - Manual (Page 12)

User's Manual LINE 212-6 / LINE 212-9
KLING & FREITAG GMBH ©2003 - 2005 Version 5.0, 23.03.2006 Page 12 of 37
5. Using the ‘allsafe JUNGFALK’ Flying Points
Single Stud Fitting
Used as fastener to the ‘allsafe
JUNGFALK’ Flying Point.
‘allsafe JUNGFALK’ Flying Point
Receptacle for special fasteners.
1.) 2.)
Take the single stud fitting in one
hand... ... and push the locking device up
against the spring tension.
3.) 4.)
Put the flat head of the holding
bolt into the guiding of the flying
point. Release the locking device when
the single stud fitting is located in
the middle of the flying point.
Make sure that the locking device
clicks into place.
5.)
Check that the single stud fitting is
securely fastened and cannot be
pulled out.
Warning