KLING & FREITAG K&F Line 212-9 - SP - Manual (Page 23)

User’s Manual LINE 212-6 - SP / LINE 212-9 - SP
KLING & FREITAG GMBH ©2003 - 2014 Version 5.0, 09.09.2014 Page 23 of 44
10. Wiring
Before connecting your SP system, be sure to switch off all connected appliances and
turn down all level controls.
− We recommend the use of high-quality cables provided by KLING & FREITAG.
− For connections to the line signal inputs, please use 2-pin shielded microphone cable
with high-quality connectors.
− Avoid ground loops (see chapter 10.1 )
− Make sure that the pin assignment of the line level connectors is correct. (2 +/ 3 - / 1 ┴).
10.1 Avoiding Ground Loops
10.1.1 What is a Ground Loop?
Every component of a P.A. or Hi-Fi System has its own internal 0V reference (ground). This
point is often connected to the protective earth connector (PE / Ground). If two or more
units are connected to one another with a line level audio cable, there may be a ground
connection through the ground of the power supply cable (yellow-green) as well as
through the shielding of the audio cable. The voltage difference between these two
ground points causes audible interference to come from the speaker.
10.1.2 Avoiding Ground Loops
If there is a loud humming or buzzing after the ‘SP’ System has been connected, then
set the ‘Ground Lift’ switches on the rear of the ‘SP’ speakers to the ‘Lift’ position (chap-
ter: 3 / section 2)
If the noise is still audible, check if
1. the noise is caused by a ground loop before the speakers (e.g. mixing console,
effects or equalizers).
2. the system or parts of the system are connected to an ‘unclean’ power supply -
meaning one which is also running large motors or lighting systems. An ‘un-
clean’ supply voltage, electrostatic and electromagnetic fields can cause inter-
ference
Please observe the following basic rules:
− Never !!! try to avoid a ground loop by disconnecting or taping the ground
contact at the connector! Extremely dangerous!
− If possible, only use high-quality audio appliances with balanced signal outputs and
power cables with PE connectors.
− Use high-quality cables with good shielding.
− The point of ground for all connected components should merge at one central
point. The power connections should lead out in a radial manner from one point
and not be linked from one unit to the next.
− When installing appliances that create strong electrostatic or electromagnetic fields
(large transformers, switch-mode power supplies), maintain some distance from
other audio appliances. In extreme cases, the only solution is to create a completely
independent ‘audio ground’; in other cases, it is sufficient to connect a filter in front
of the audio equipment.
Warning