Monroe Electronics Charge Plate - Analyzer - model 300 - Manual (Page 12)

12
Figure 5. Rear View Showing Plate Assembly In Operational Position On Top of Console Unit
the console unit. Then slide it forward in the guide channel to insert it into the operational
position.
Connect the 6-inch CAT 5 cable between the plate assembly and the console unit.
NOTICE: The power should be off when connecting the plate assembly to
the console.
NOTICE: We recommend returning the plate assembly to the storage
position for transport.
Remote Placement of the Plate Assembly
Turn off the Model 300 before detaching the ion collecting plate from the console.
Disconnect the cable connecting the ion collecting plate to the console.
Slide the ion collecting plate backwards to remove it from the console.
Reconnect the ion collecting plate to the console using the 5-foot-long cable provided.
NOTE: When it is detached from the console, the ion collecting plate maintains a ground
connection via this cable.
NOTE: This cable is a standard CAT 5 cable. Longer cables can be purchased and used
when greater separations between the ion collecting plate and the console are needed.
Navigating the Front Panel
Three operations can be performed from the system prompt ( -.-).
1. Perform ionizer tests- initiate tests directly from the system prompt, -.-.
2. Recall test results- press the Shift/Cancel button once to recall test results for the
Model 300.
3. Feature Set Up- press the Shift/Cancel button twice to set up features for the
Model 300.