Monroe Electronics R184 User Manual

Page 21

Advertising
background image

• Notice that two configurations are shown.
• The first one is to use unit 154 as a single unit, and the second one is to use unit 154 as the
master in a matrix.
• Highlight the matrix selection, then click RS485 Termin. On. [Of course, you have connected
the end connector on the RS485 serial wiring to the Master unit prior to this.]
• Verify that the yellow CNTL Terminal LED on the front panel of the master unit is lit.
• Click on Operate to go to the operation screen.

21

Advertising