NEXCOM NSA 3130 - Manual (Page 57)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 44 NSA 3130 User Manual
Default Configuration
Most of the configuration settings are either predefined
according to the Load Optimal Defaults settings which
are stored in the BIOS or are automatically detected and
configured without requiring any actions. There are a
few settings that you may need to change depending on
your system configuration.
Entering Setup
When the system is powered on, the BIOS will enter the
Power-On Self Test (POST) routines. These routines
perform various diagnostic checks; if an error is
encountered, the error will be reported in one of two
different ways:
•
If the error occurs before the display device is
initialized, a series of beeps will be transmitted.
• If the error occurs after the display device is
initialized, the screen will display the error message.
Powering on the computer and immediately pressing
<Del> allows you to enter Setup. Another way to enter
Setup is to power on the computer and wait for the
following message during the POST:
TO ENTER SETUP BEFORE BOOT PRESS
<CTRL-ALT-ESC> Press the <Del> key to enter
Setup:
Legends
Key Function
Right and Left arrows Moves the highlight left or
right to select a menu.
Up and Down arrows Moves the highlight up or
down between submenus or
fields.
<Esc> Exits to the BIOS Setup
Utility.
+ (plus key) Scrolls forward through the
values or options of the
highlighted field.
-(minus key) Scrolls backward through
the values or options of the
highlighted field.
Tab Select a field.
<F1> Displays General Help.
<F10> Saves and exits the Setup
program.
<Enter> Press <Enter> to enter the
highlighted submenu.