Paxton Superchargers Mustang Novi 1220 - Manual (Page 13)

P/N: 4809631
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
23MAY07 v1.0 Template(4809631v1.0)
4-1
Section 4
OIL FEED LINE
4.0 OIL FEED LINE ASSEMBLY
A. Remove the oil pressure sender and mounting
boss fitting from the engine. These are found
on the engine's left side just ahead of the oil
filter.
B. Thread the supplied 3" x 1/4"NPT nipple into
the block using engine oil on the threads. Pipe
tape, paste or other sealant is not recommend-
ed as it might loosen and cause blockage of
the oil feed orifice, resulting in supercharger
failure.
C. Thread the supplied 1/4" female TEE into the
nipple. Rotate the TEE so that the center leg
points toward the front of the vehicle. Thread
the 45° elbow into the leg of the TEE and
pointing toward the side of the vehicle.
D. Install the factory sending unit into the 45°
elbow.
E. Thread the supplied flared fitting into the
remaining leg of the TEE.
F. Connect the red oil feed line to the fitting at
the pressure sender and route it behind the
A/C mounting plate to the supercharger loca-
tion. Cover the end of the hose with a clean
plastic bag. Connect the line to the super-
charger with the flared fitting provided.
Fig. 4.0-a
3” NIPPLE
1/4” TEE
45
°
ELBOW