Paxton Superchargers Mustang Novi 1220 - Manual (Page 31)

P/N: 4809631
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
23MAY07 v1.0 Template(4809631v1.0)
13-1
Section 13
CHECK-OUT PROCEDURES
*** WARNING ***
Do not attempt to operate the vehicle until all compo-
nents are installed and all operations are completed
including the final check.
A. Reconnect the battery.
B. If your vehicle has gone over 10,000 miles
since its last spark plug change, you will need
to change the spark plugs now before test
driving the vehicle.
C. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and
fuel lines around moving parts, sharp edges
and exhaust system parts. Make sure all wires
and lines are properly secured with clamps or
tie-wraps.
D. Check all fluid levels, making sure that your
tank is filled with 91 octane or higher fuel
before commencing test drive.
E. Visually inspect the fan, belts and shroud for
clearance before running the vehicle. Pay spe-
cial attention to the upper radiator hose-to-belt
and pulley clearance.
F. Start the engine and allow to idle for a few
minutes, then shut off.
G. Recheck to be sure that no hoses, wires, etc.
are near exhaust headers or moving parts, and
for signs of any fluid leakage. Check ignition
timing to make sure it is set to stock specifica-
tions before commencing test drive.
H. PLEASE TAKE SPECIAL NOTE:
Operating the vehicle without ALL the sub-
assemblies completely and properly installed
may cause FAILURE OF MAJOR COMPO-
NENTS.
I. Test drive the vehicle.
J. The supercharger drive belt stretches initially
and will require adjustment between 250 and
400 miles.
K. Read the Street Supercharger System Owner's
Manual and RETURN the Warranty REGIS-
TRATION FORM within thirty (30) days of
purchasing your supercharger system to qualify.
13. FINAL CHECK