Signamax 8-Port 100BaseFX Fiber Unmanaged Switches User Manual
Page 13
Signamax
065-7310F 8-Port 100BaseFX Fiber Switches
User Manual 11
Connecting to Power
Connect the supplied AC power cord to the receptacle on the
back of the switch, and then plug the cord into a standard AC
outlet with a voltage range from 100 to 240 VAC.
Turn the Ethernet switch on by flipping the ON/OFF switch on
the rear of the unit to the I (ON) position. The O position is
OFF.
Figure 3: Rear view of the switch
Connecting to Your Network
Prepare a pair of fiber optic cables with SC or ST type
connectors at both ends.
If you are making a connection to a server or workstation, be
sure that it has a properly installed 100BaseFX network
interface card. Connect the Rx/Tx jacks on the target device
to the Tx/Rx jacks on the switch.