Xilica NeuPanel Series - Manual (Page 4)

Installation Guide NeuPanel Series - Mini Controls (v3.2)
Xilica Audio Design www.xilica.com [email protected] Page 4
Mini Control - Wall Mounting Requirements
Surface Mount
1. Surface mount back box/can and Mini mounting screws - 4 x M8 metric thread - are included in the product carton
2. CAT5e or CAT6 cable with a RJ45 connector
3. Power - PoE switch or PoE injector (not included) or 5VDC external power supply (included)
4. Screws to mount Mini surface mount back box to the wall or surface (not included)
Flush Mount
New Construction
1. Electrical back box/can, 2 gang, 2" deep (not included)
2. Mud ring (if utilized), 2 gang 1 ⁄2" or 3⁄4" depending on installation (not included)
Note: The internal corners of different cut-in ring/box brands can vary and interference may be an issue. It is important to know
some minor corner modifications may be required.
3. 6 ⁄32 x .75" Qty 4 screws (included in a bag with each Mini) to mount the Mini control into N. America new construction electrical
boxes. Or use the supplied metric M8 screws that are used to mount the Mini control into the supplied surface box included in
the product carton for new construction electrical boxes In Europe and Asia.
4. CAT5e or CAT6 cable with a RJ45 connector
5. Power - PoE switch or PoE injector (not Included) or 5VDC external power supply (included)
Existing Construction
1. 2 gang cut in ring (not included)
The Cooper Industries B-Line brand of cut-in ring part # BB20L (N. America) will fit nicely as it lies thin and flat against the wall
Note: The internal corners of different cut-in ring/box brands can vary and interference may be an issue. It is important to know
some minor corner modifications may be required.
2. 6 ⁄32 x .75 Qty 4 screws (included in a bag with each Mini) to mount the Mini control into N. American cut in rings. Or use the
supplied M8 metric screws that are used to mount the Mini control into the supplied surface box included in the product carton
for existing construction cut-in rings in Europe and Asia.
3. CAT5e or CAT6 cable with a RJ45 connector
4. Power - PoE switch or PoE injector (not Included) or 5VDC external power supply (included)
Rack Mount
Rack Mount 19" Width Racks - 3RU Panel - Pre-Cut 2-Gang Threaded Cutouts (Up to 3 Mini Controls Per Panel)
1. Optional Mini-RMKIT rack mount panel
2. CAT5e or CAT6 cable with a RJ45 connector
3. Power - PoE switch or PoE injector (not included) or 5VDC external power supply (included)
4. Included 4 x M8 metric thread screws to mount the Mini control into the Mini-RMKIT rack mount panel. Or use the 6 ⁄32 x .75" Qty 4
screws (included in a bag with each Mini) to mount the Mini control into rack mount panels manufactured in N. America.