Xtramus LB-300 V1.0 - Manual (Page 7)

7
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
1.3. LB-300 Specifications
Model Name LB-300
Frame Format ¾ Ethernet II frame ¾ IEEE 802.3 frame
Left Side Right Side
Interface
Ports
10/100/1000 Mbps UTP Ethernet Port × 1
(10/100 Mbps Half/Full Duplex, 1000 Mbps Full Duplex)
USB Port (Mini-USB Connector) × 1
Power Switch × 1
Throughput
Test
¾ Throughput result for frame length, 64/128/256/512/768/1024/1518 bytes, steps by
steps, or configuration in specified range by user
¾ Throughput result according to user defined packet loss tolerance in percentage
¾ Throughput result in percentage that is based on 100 Mbps utilization
¾ Throughput result in FPS (frame per second)
Latency Test
¾ Latency test for frame length, 64/128/256/512/768/1024/1518 bytes, steps by steps, or
configuration in specified range by user
¾ Latency test result according to user defined utilization in percentage
¾ Average Latency in us(microsecond)
¾ Test result according to 2 definitions of RFC2544, Store and Forward, and Cut Through.
Hardware Information
Dimension 141 mm x 22 mm x 22 mm
Temperature ¾ Operating: 0°C~ 40°C (32°F~ 104°F) ¾ Storage: 0°C~ 50°C (32°F~ 122°F)
Humidity ¾ Operating: 0% ~ 85% RH ¾ Storage: 0% ~ 85% RH
Power Source
Two built-in 3.7V NI-MH batteries which can be recharged via LB-300’s Mini-USB Port
while connected with PC
Supporting Softwares
Supporting
Softwares
¾ For Loopback Mode with NuDOG-301, NuDOG-301 and utility software DApps-2544 are
required
¾ LB Utility for updating firmware and FPGA