Xtramus NuPOE-M16EL V1.1 - Manual (Page 8)

8
E-mail: [email protected]
Website: www.Xtramus.co
m
XTRAMUS
2 Hardware Description
This section describes the general information of the hardware interfaces of the NuPOE-M16EL chassis
and its modules.
2.1 Chassis
NuPOE-M16EL has 16 slots for installation of the PD emulation modules ( XL-T451 ), 1 Fan slot, 1 Casc
slot and 1 Mgm slot. Besides, there are two arrays of FAN LEDs, up and down on the panel, to shown the
running statues of the fans installed on the top and bottoms of the chassis, respectively. You can see the
number or the name of the slot clearly on the front panel. The front panel of NuPOE-16El is shown as
below.
NuPOE-M16EL Slots
Fan Slot Slot for installing XL-SFAN .
PD Emulation
Module Slots
16 slots, from slot2 to slot17, for installing XL-T451 .
Casc Slot for installing XL-CASC .
Mgm Slot Slot for installing XL-M667 .
Warning: XL-SFAN, XL-T451, XL-CASC, and XL-M667 do not support hot-swap. Do not draw them
out of the chassis when the system is power on.