Features, functions, and specifications, Introduction, Features and functions – AMETEK SFA Series Programming Manual User Manual
Page 7: Section 1, Features, functions, and specifications -1, Introduction -1, Features and functions -1
SECTION 1
1.1 Introduction
1.2
FEATURES, FUNCTIONS,
AND SPECIFICATIONS
This manual covers the Digital Interface Adapter (DIA) for SF Series supplies. The DIA interface
card enables the user to operate from a computer via the IEEE-488.2 GPIB or RS-232 interface,
allowing full remote programming control and monitoring of the SF Series supply.
Features and Functions
Features
• 16-bit programming and 16-bit readback of voltage and current
• IEEE-488.2 and SCPI compliant command set
• Current Ramp functions
• Field-upgradable firmware via RS-232
• Soft
calibration
• Rear panel IEEE-488.2 and RS-232 control interface
• Rear panel configuration switch
Programmable Functions
• Output
current
• Soft limits for current
• Output
enable/disable
• Maskable fault interrupt
• Hold and trigger
• Full
calibration
M550292-03 (Programming)
1-1