AMETEK SLM-4 - Manual (Page 21)

SECTION 3
OPERATION
3.1 INTRODUCTION
The front panel of the SLM-4 chassis is shown in Figure 3–1.
Figure 3–1 SLM-4 Chassis Front Panel
3.2 POWER CONNECTION
Before connecting AC power to the SLM chassis, make sure the power source matches the
power requirements of the SLM Electronic load chassis (as marked on the rear panel) per
Section 2.1.1. The power switch in the lower left corner of the chassis turns power On/Off to the
chassis and to all SL-series electronic load modules.
PREVENT DAMAGE TO THE LOAD: Do NOT apply voltage or current with power
switched OFF. Turn ON the power switch to the load PRIOR to applying voltage or
current to the input terminals (i.e., before turning on the power supply under test).
M540069-01 Rev B 3-1