Document Outline

• XFR 2800 Watt Series Programmable DC Power Supply Operation Manual
  • About AMETEK
  • Safety
  • Warranty
  • Contents
• Features and Specifications
  • Description
  • Features and Options
  • Front Panel Controls
  • Rear Panel Connectors and Switch
    • Rear Panel SW1 Switch
      • Resetting the Switches
    • Rear Panel J2 Connector
      • Making J2 Connections
      • Wiring
• Installation
  • Basic Setup Procedure
  • Inspection, Cleaning, and Packaging
    • Initial Inspection
    • Periodic Cleaning
    • Packaging for Shipping or Storage
  • Location, Mounting, and Ventilation
    • Rack Mounting
    • Ventilation
  • AC Input Power
    • AC Input Connector and Voltage Selection
    • AC Input Cord
    • AC Input Wire Connection
  • Functional Tests
    • Equipment Required
    • Power-on Check
    • Voltage Mode Operation Check
    • Current Mode Operation Check
    • Front Panel Function Checks
  • Load Connection
    • Load Wiring
      • Insulation Rating
      • Current Carrying Capacity
      • Load Wiring Length for Operation with Sense Lines
      • Noise and Impedance Effects
    • Making Load Connections
      • Output Cover
      • 7.5 V to 100 V Models
      • 150 V to 600 V Models
    • Inductive Loads
    • Connecting Single Loads
    • Connecting Multiple Loads
  • Local and Remote Sensing
    • Sense Wiring
    • Local Sensing
    • Using Remote Sensing
• Local Operation
  • Introduction
  • Standard Operation
    • Operating Modes and Automatic Crossover
      • Constant Voltage Mode Operation
      • Constant Current Mode Operation
      • Automatic Mode Crossover
    • Shipped Configuration (Local Control Mode)
    • Setting Output Voltage and Current Limit
  • Using Over Voltage Protection (OVP)
    • Front Panel OVP Operation
    • Resetting the OVP Circuit
  • Using the Shutdown Function
    • STANDBY Switch
    • Controlling the Shutdown Function via the J2 Connector
  • Using Multiple Supplies
    • Configuring Multiple Supplies for Series Operation
    • Configuring Multiple Supplies for Parallel Operation
      • Sensing for Parallel Operation
    • Configuring Multiple Supplies for Split Supply Operation
      • Two Positive Voltages
      • Positive-negative Supply
  • Over Temperature Protection (OTP)
• Remote Operation
  • Introduction
    • Isolated Programming
    • Remote Digital Programming
  • Remote Analog Programming of Output Voltage and Current Limit
    • Remote Programming Options
    • Remote Analog Programming Procedure
  • Remote Monitoring of Output Voltage and Current
    • Readback Signals
• Calibration and Troubleshooting
  • Calibration Setup
    • Service Environment and Precautions
    • Equipment Required
    • Accessing Calibration Potentiometers
      • Removing Option Card
  • Calibrating for Programming Accuracy
    • Voltage Programming Circuit Calibration
    • Current Limit Programming Circuit Calibration
  • Calibrating for Readback Accuracy
    • Output Voltage Monitor Circuit Calibration
    • Output Current Monitor Circuit Calibration
  • User Diagnostics
    • Emergency Shutdown
    • Unusual or Erratic Operation
    • Troubleshooting for Operators
• Specifications
  • Electrical Specifications
  • Additional Specifications
  • Input Conditions
  • Additional Features
  • Remote Programming and Monitoring
  • Environmental Specifications
  • Mechanical Specifications
  • Warranty
  • Return Material Authorization Policy
  • Return Procedure
  • Out of Warranty Service
  • Information About Your System