AMETEK XPH 35-5 User Manual
Xph series 75v 2a dual
Advertising
Table of contents
Document Outline
- Table of Contents
- Introduction
- Specification
- Safety
- Installation
- Connections
- Operation
-
- Setting Up the Output
- Constant Voltage
- Constant Current
- Instantaneous Current Output
- Mode Selection
- Caution. Turn both outputs off before changing mode. Possible damage to the circuit being powered, and to the unit itself, may occur if the mode is switched with either output still on.
- Mode A: With the switch in this position the outputs operate independently and are isolated from one another. The voltage range on each output is 0-75V and the current range 0-2A.
- Mode B: With the switch in this position only Output 2 is active; the voltage range is 0-75V and the current range is 0-4A. The controls of Output 1 are inoperative and the display is blanked. The terminals of Output 1 are isolated from those of Outp
- Mode C: With the switch in this position only Output 2 is active; the voltage range is 0-150V and the current range is 0-2A. The controls of Output 1 are inoperative and the display is blanked. The red terminal of Output 1 is isolated but the black t
- Protection
- Connection to the Load
- Series or Parallel Connection with Other Outputs
-
- Maintenance
- Sécurité
- Installation
- Connexions
- Fonctionnement
-
- Réglage de la sortie
- Tension constante
- Courant constant
- Sortie de courant instantanée
- Sélection de mode
- Attention. Désactiver les deux sorties avant de
- Mode A: Le commutateur dans cette position, les s
- Mode B: Le commutateur dans cette position, seu
- Mode C: Le commutateur dans cette position, seule
- Protection
- Connexion à la charge
- Connexion en série ou en parallèle avec d’autres
-
- Maintenance
- Sicherheit
- Installation
- Anschlüsse
- Betrieb
- Wartung
- Sicurezza
- Installazione
- Collegamenti
- Funzionamento
- Manutenzione
- Seguridad
- Instalación
- Conexiones
- Operación
-
- Ajuste de la Salida
- Tensión Constante
- Corriente Constante
- Salida Instantánia de Corriente
- Selección de modo
- Precaución. Desactive ambas salidas antes de cam
- Modo A: Con el interruptor en esta posición, l
- Modo B: Con el interruptor en esta posición, s
- Modo C: Con el interruptor en esta posición, s
- Protección
- Conexión a la Carga
- Conexión en Serie o en Paralelo a Otras Salidas
-
- Mantenimiento
- Warranty Information