Aplex Technology APC-3284A - Manual (Page 62)

APC-3x84A /APC-3x85AUser Manual 62
Multiple Monitors
Multiple Monitors support from two to six touch screen displays for one system.
The PenMount drivers for Windows 2000/XP support Multiple Monitors. This function supports from
two to six touch screen displays for one system. Each monitor requires its own PenMount touch
screen control board, either installed inside the display or in a central unit. The PenMount control
boards must be connected to the computer COM ports via the RS-232 interface. Driver installation
procedures are the same as for a single monitor. Multiple Monitors support the following modes:
Windows Extends Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
NOTE: The Multiple Monitor function is for use with multiple displays only. Do not use this function if
you have only one touch screen display. Please note once you turn on this function the
rotating function is disabled.
Enable the multiple display function as follows:
1. Check the Enable Multiple Monitor Support box; then click Map Touch Screens to assign
touch controllers to displays.
2. When the mapping screen message appears, click OK.