dbx Pro 260 - Manual (Page 31)

®
Configuring the DriveRack™
Section 3
DriveRack ™
23 DriveRack™ User Manual
User Configuration is an ideal feature available in the 260 DriveRack. Even with the versatility
of the Factory configurations within the DriveRack, there may be an application that requires a
unique “custom” program configuration. The DriveRack gives you the ability to create a cus-
tom routing configuration by selecting and modifying the modules including: Inputs, pre-
crossover EQ, an insert section which includes: Notch Filter, Compressor, Gates, AGC,
Subharmonics Synthesizer and AFS (Advanced Feedback Suppression), Crossovers, Post-
crossover Parametric EQ, Dynamics, Post Delay, Output Gain and Phase. The following infor-
mation contain a standard block diagram of the signal path in the 260 DriveRack which can be
used as a reference map, as well as step-by-step instructions for creating custom user configu-
rations.
260 Signal Path
• From Program mode, press and hold the PROGRAM/CONFIG button until the bot-
tom corner of display reads: “Configure”
• At this point, you can either press the button of the module that you wish to edit ie:
DYNAMICS, or if you wish to change every module within the signal path, you can
use the PREV PG and NEXT PG buttons to move through every module within the
signal path. The following information will make a basic touch on every module.The
first page in configuration mode will appear as follows:
”
• You are now in the Pre-Crossover EQ module. The arrow indicates that EQ type is
selected. Rotate the DATA wheel to select either Parametric (PEQ) or Graphic
(GEQ). Pressing and then rotating the DATA wheel lets you link or unlink the A and
GEQ
Select
Link/Unlink
GEQ
GEQ A
B
260 Signal Path
WIRE
RTA
MIXER
ROUTING
A
B
A+B
RTA
3.5 Creating a User Configuration