Wired (ethernet) network setup (continued), Connecting to the web management interface, Wired (ethernet) network setup – ARRIS 2247-N8-10NA User Manual User Manual
Page 14: Inue with, Wired, Ethernet) network setup, 1 and 2 of
Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit
www.motorola.com/us/support
for FAQs and additional product documentation.
13
Wired (Ethernet) Network Setup
With the 2247-N8 powered on, use the following steps to make a wired
connection from a computer to the Ethernet ports on the 2247-N8:
1. Locate the yellow Ethernet cable included in the package. Insert the
plug on one end of the cable into any of the four yellow ports on the
back of the 2247-N8. The connector will only fit into the port one
way. Insert the connector until the locking tab clicks into place.
2. Insert the other end of the Ethernet cable into an Ethernet network-
ing port on your computer. Press the connector into the port until the
tab clicks into place.
Once the Ethernet devices are connected to the 2247-N8, your net-
work may resemble the figure shown to the right.
Note:
Almost every device is configured to get its network information
automatically using “DHCP,” and you should not need to configure your
computer. If you have trouble getting to the 2247-N8 Web page in the
next step, you can check your computer’s network settings in
2247-N8 Ethernet Installation
Connecting to the Web Management Interface
3. Once you are connected to the 2247-N8, open a Web browser and
type
http://192.168.1.254
into the address bar. Press Enter.
A Welcome to your Motorola Router window appears.
2247-N8 Web Management Interface Address