Dhcp server – ARRIS 2247-N8-10NA User Manual User Manual
Page 20
Motorola 2247-N8 DSL Wi-Fi Gateway User Guide
Please visit
www.motorola.com/us/support
for FAQs and additional product documentation.
19
DHCP Server
Use the DHCP Server Configuration page to change the Dynamic Host Configuration Protocol (DHCP) settings on your 2247-N8. The 2247-N8 will
serve DHCP addresses starting with the primary subnet and then serve addresses from additional subnets in the order they were added. Remember
to click
Apply Changes
to make sure your updates are saved.
Important:
The DHCP server for the primary subnet must be enabled and serving at least one IP address in order for the DHCP server feature to
serve addresses for additional subnets.
DHCP Server Configuration Page
Router IP Address
- The 2247-N8 LAN IP address. The default setting is 192.168.1.254
Subnet Mask
- The 2247-N8 LAN subnet mask. The default setting is 255.255.255.0
DHCP Server Enable
- Enables or disables the 2247-N8 DHCP server. Clear the check box if you have another DHCP server that provides
addresses to your network. The default setting is enabled (box selected).
DHCP Start Address
- This address must be in the same subnet as the Router IP Address you entered above. For example, with the Router
IP Address listed above, you could use a DHCP start address of 192.168.1.64.
DHCP End Address
- This address must be in the same subnet as the Router IP Address you entered above. For example, with the Router IP
Address listed above, you could use a DHCP end address of 192.168.1.253.
DHCP Lease
- Enter a lease time in dd:hh:mm:ss (days/hours/minutes/seconds) format. The default setting is one day.