Semi-parametric eq, Figure 3 – equalizer section, Eq bypass switch – ART Pro Audio ProChannel II User Manual
Page 10: Clip led
9
Semi-Parametric EQ
The ART Pro Channel II™ offers a four-band semi-parametric equalizer. The entire EQ can be bypassed with
a single switch. Each band has + 12dB of control range.
The High and Low EQ bands are shelving type with a switch selectable turnover point.
The two Mid bands can be continuously tuned over a three octave range, plus a range switch adds another
three octave range. You can adjust the filter "Q" to be either narrow or wide via separate switches.
FIGURE 3 – Equalizer Section
EQ Bypass Switch
This switch allows you to instantly set the EQ completely flat without loosing the current EQ settings.
CLIP LED
This LED indicates clipping in any section of the Pro Channel II™.
You can isolate the source of the clipping to the INPUT section by reducing the Preamp output, if the clipping
LED remains lit. If the Clip LED goes out, the clipping is in the compressor or EQ section.
You can prevent clipping in the EQ section by reducing the Compressor output.