ART Pro Audio ProChannel II - Manual (Page 14)

13
EQ IN Jack
This 1/4” T/S unbalanced jack is an input to the EQ and dynamics processing sections. This input can be
used in conjunction with the MIC PREAMP OUTPUT jack to insert external signal processors between the
main preamp section and the EQ and dynamics processing of the Pro Channel II™.
OUTPUT Jacks
The analog output of the Pro Channel II™ is available on both a 1/4” TRS balanced jack and an XLR jack.
This output is active balanced, and will adjust to balanced or unbalanced termination without gain change.
OUTPUT LEVEL Switch
This switch optimizes the output level of the Pro Channel II™ depending on the equipment you are driving.
When this switch is in the out position, the balanced output measures -10dBV (about 0.3V RMS). This is the
appropriate setting when connecting to most semi-pro or consumer equipment.
When depressed, the XLR output of the unit measures +4dBu (about 1.2 Volts RMS) when the Output Meter
reads "0" VU. Use this setting when connecting up to professional line level gear.