Artel DLC150E - Manual

Simplifying Media Transport ™
DigiLink Media Transport Simplified
QUICK START GUIDE
SW4 CONFIGURATION SIGNAL SOURCE
Function Off On
S4
Audio
Source
AES Digital Analog
S5
Analog
Audio Mode
20 bits 24 bits
Factory Default: All On
Artel ships the DLC150E configured as follows:
• Analog audio mode set to 24 bits
• Analog audio source with 600 ohm termination
• +20 dB peak audio level without clipping
• Asynchronous audio embed into destination group #1
• Digital video enabled through the BNC connector
• SDI grey field enabled if no video is present at the NTSC rate
• Alarm enabled if no SFP is present
• EMS override enabled (DigiLink Manager can change the DLC150E configuration)
DIP Switch Configurations
SW3 CONFIGURATION PEAK AUDIO
LEVEL
SW Function
0 +10 dBm
1 +12 dBm
2 +14 dBm
3 +16 dBm
4 +18 dBm
5 +20 dBm
6 +22 dBm
7 +24 dBm
Factory Default: +20 dBm
SW2 CONFIGURATION
ANALOG AUDIO TERMINATION
Function Off On
S1 Audio Ch D High Z 600 ohm
S2 Reserved - Must be On
S3 Audio Ch C High Z 600 ohm
S4 Reserved - Must be On
S5 Audio Ch B High Z 600 ohm
S6 Reserved - Must be On
S7 Audio Ch A High Z 600 ohm
S8 Reserved - Must be On
Factory Default: All On
SW2 Controls the termination of the
analog audio inputs
SW3 Controls the peak analog audio
( Rotary level that can be handled without
Switch) clipping
SW4 Controls the signal source selection
for the digital video, type of audio,
and destination group for the
embedding
SW5 Controls multiple module
operating states including:
conditional embedding, non-video
keep-alive signal, line rate for the
standby video pattern, digital audio
rate converter operation, optional
alarm suppresssion for an uninstalled
SFP, and EMS control mode
SW5 CONFIGURATION
MODE CONTROL
Audio Embed Mode S1 S2
Group Embed (See SW4: S6, S7) On On
Always Embed On Off
No Embed Off Off
Reserved Off On
Factory Default: All On
Function Off On
S3 Standby Signal Artel* SDI Grey
S4 Standby Type 625 Line 525 Line
S5 Rate Converter Sync Async
S6 SFP Alarm Disabled Enabled
S7 Reserved - Must be On
S8 EMS Override
Local
Control
Remote
Control
•Non-video keep-alive signal.
Factory Default: All On
SW4
SW5
SW2
SW3
Configuration Switch Functions
Function Off On
S8 Reserved - Must be On
Factory Default: On
SW4 CONFIGURATION SIGNAL SOURCE
S1 S2 S3 Video Source
On On On SDI BNC In
Off Off Off Backplane 1
On Off Off Backplane 2
Off On Off Backplane 3
On On Off Backplane 4
Off On On SFP Opt Receiver
Off Off On Reserved
On Off Off Reserved
Factory Default: All On
S6 S7 AUDIO DESTINATION
On On Group 1
Off On Group 2
On Off Group 3
Off Off Group 4
Factory Default: All On
SDI/SDTI 4 Channel Analog/Digital AES Audio
Embed and Optical Transmitter [DLC150E]