96 testrambounce, Testrambounce, Motload commands – Artesyn MOTLoad Firmware Package User's Manual (February 2015) User Manual
Page 184
MOTLoad Commands
MOTLoad Firmware Package User’s Manual (6806800C24D)
184
3.1.96 testRamBounce
Name
testRamBounce—writes all ones to all memory addresses within the default or specified
memory block, then performs a read-back and verify of each memory address. If a mis-
compare is detected, an error is logged. This operation is repeated a second time but the write
data is all zero.
Note: testRamBounce only test memory in blocks, thus specifying a memory area size that is
not a multiple of the block size results in part of the memory area being untested.
Synopsis
testRamBounce [-a] [-b] [-i] [-n] [-t] [-v]
Parameters
-a Ph: Address to Start (Default = Dynamic Allocation)
-b Ph: Block Size (Default = 16 KB)
-i Pd: Iterations (Default = 1)
-n Ph: Number of Bytes (Default = 1 MB)
-t Pd: Time Delay Between Blocks in OS Ticks (Default = 1)
-v 0: Verbose Output
Example
The following example indicates a typical display when using the testRamBounce command.
MOTLoad> testRamBounce -v
Executing RAM Bounce: PASSED
See Also
,
,