Artesyn MOTLoad Firmware Package User's Manual (February 2015) - Manual (Page 265)

VME Configuration Parameters
MOTLoad Firmware Package User’s Manual (6806800C24D) 265
 vmeCfg –e –rF70
Edits VMEbus Register Access Image Control Register state
C.5 Deleting VME Settings
To delete the changeable VME setting (restore default value), for example on a Universe II PCI-
to-VMEbus bridge, type the following at the firmware prompt:
 vmeCfg –d –m
Deletes Master Enable state
 vmeCfg –d –i(0 - 7)
Deletes selected Inbound Window state
 vmeCfg –d –o(0 - 7)
Deletes selected Outbound Window state
 vmeCfg –d –r184
Deletes PCI Miscellaneous Register state
 vmeCfg –d –r188
Deletes Special PCI Target Image Register state
 vmeCfg –d –r400
Deletes Master Control Register state
 vmeCfg –d –r404
Deletes Miscellaneous Control Register state
 vmeCfg –d –r40C
Deletes User AM Codes Register state
 vmeCfg –d –rF70
Deletes VMEbus Register Access Image Control Register state
C.6 Restoring Default VME Settings
To restore all changeable VME settings back to default settings, type the following at the
firmware prompt:
vmeCfg –z