Avalon Firestyles 21 DV RV - Manual (Page 13)

Installation (for qualified installers only) 13
© Travis Industries 4060517 100-01158
Optional Gas Line Location
Secure the cover plate to the access cover with the
nuts removed in step “b”. Secure the access cover to
the fireplace with the screws removed in step “a”.
d
1/4" Nutdriver
Remove the access cover on the
side of the fireplace.
a
HINT: remove the
control cover for
easier access. 5/16" Wrench
Remove the cover plate on the bottom
of the fireplace (save these nuts).
b
c Position the gas inlet assembly over the hole in the
baseplate and secure using the screws removed in
step “a” (NOTE: bend the flex tube as shown below -
this will ease in positioning of the gas inlet assembly).
Electrical Connection
•
Make sure the household breaker is shut off prior to working on any electrical lines.
•
The fireplace must be properly grounded in accordance with local codes (or ANSI/NFPA 70-1987)
•
The electrical line must be 14 gauge, and supply 120 Volts at 60 Hz (2 Amps)
Electrical Line Location
Optional Location
The optional electrical inlet is flush
with the base of the fireplace.
NOTE: a 3-1/2" diameter hole is required to
provide clearance for the electrical inlet screws.
10-1/2"
8"
Standard Location
10-1/2"
Front of Fireplace