Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 11)

Fig. 7-1
Non-Ratchet End
Ratchet End
Take Up Rail Left Arm Rail Holder End
Take Up Rail Right Arm Ratchet End
Fig. 8-1
Fig. 8-2
Backside of
the carriage
Sensor
Bracket tab
M6 Set Screw
Fig. 6-3
M8 Nylock Nut
M8 x 50mm SBHCS
Page. 10
Parts Needed:
1- Take Up Rail Right Arm Ratchet End
1- Take Up Rail Left Arm Rail Holder End
2- M8 x 50mm SBHCS
2- M8 Nylock Nut
Tools Required:
5mm Allen Wrench
Open Wrench 13mm and 10mm
Note: The height may need to be adjusted after
the sewing machine has been set on the frame.
This assembly step is universal for both Crib and
King size frames.
7-1: Insert the Rail Brackets into the corresponding
tube ends. (Fig. 7-1)
7-2: Fasten a set of M8 x 50mm SBHCS and M8
Nylock Nuts through the middle hole of the Rail Arm
Brackets. (Fig. 7-1)
Parts Needed:
2- M6 Set Screw
1- Sensor Bracket
1- Carriage Assembly (included
with sewing machine)
1- Master Board Box
1- Power Supply
Tools Required:
3mm Allen Wrench
8-1: Attach and align the Sensor Bracket to the
backside of the carriage. The Sensor Bracket tab
should be flush against the rear of the carriage.
(Fig. 8-1)
8-2: Insert and fasten a set of M6 Set Screws
into the Sensor Bracket. (Fig. 8-2)
Step 7: Take Up Rail Bracket Assembly
Step 8: Bottom Carriage Assembly
6-2: Fasten a set of M8 x 50mm SBHCS and M8 Nylock
Nuts through the second hole from the bottom of the Rail
Brackets as a default. (Fig. 6-2 and Fig. 6-3)