Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 13)

Fig. 10-2
Fig. 10-3
Rail Coupler
Rail Ratcheting End Rail Non-Ratcheting
End
Fig. 10-4
Fig. 10-5
Clamp Rail Coupler
Idler Rail Clamp
Locking Assembly
Idler Clamp Floating
Assembly
Fig. 10-6
Fig. 10-7
Hinges
Fig. 10-1 3mm Allen Wrench
Page. 12
Parts Needed:
4- Rail Ratcheting End
4- Rail Non-Ratcheting End
4- Rail Coupler
2- Clamp Rail Coupler
1- Idler Rail Clamp Locking
Assembly
1- Idler Clamp Floating Assembly
24 - M6 x 10mm Set Screws (Pre-
installed in the Rail Couplers)
Tools Required:
3mm Allen Wrench
Note: Loosen M6 x 10mm Set Screws if the
Rail Couplers do not easily slide into the rail
ends. (Fig. 10-1)
10-1: Insert a Rail Coupler into a Rail Ratch-
eting End. Align the holes on the Rail Coupler
with the holes in the rail ends. (Fig. 10-2 and
Fig. 10-3.)
10-2: Tighten the pre-installed M6 x 10mm
Set Screws in the ratcheting and Non-Ratchet-
ing rail ends with an 3mm Allen Wrench. (Fig.
10-4)
10-3: Repeat step 10-1 and 10-2 for the
three remaining Rail Assemblies.
10-5: Insert the Clamp Rail Couplers into an
Idler Clamp Floating Assembly End. Align the
holes on the Clamp Rail Couplers with the
holes in the rail ends. (Fig. 10-5 and Fig. 10-
6.) Align the Clamp Rails so that the hinges
are on the same side. (Fig. 10-7)
10-6: Tighten the pre-installed M6 x 10mm
Set Screws into the Idler Rail Clamp Locking
Assembly and Idler Clamp Floating Assembly
with an 3mm Allen Wrench. (Fig. 10-7)
Step 10: Rail Assembly for King