Beisler 2211-5 - Manual (Page 18)

Short Seam Automat 2211-5 Working Instructions
- B 18 -
Beisler Automated Sewing Equipment
B.2
Functions of the machine
Fig. 7/8
Fig. 7
Fig. 8
B.2.6 Machine cycle right slash selvage
The machine cycle "Sewing the right slash selvage to the
right trousers component" is performed as follows:
•
The right trousers component is positioned manually
on the working plate.
• The trousers component is clipped, the stop for the
slash selvage swivels onto the working plate.
• The right slash selvage is lined up manually at the stop.
• The trousers component with the slash selvage is trans-
ported automatically to the sewing head where it is
tucked.
• The finished sewing piece is then blown off the wor-
king table with compressed air.
• The assistance transport is deactivated.
B.2.7 Right trousers component line-up
Ideally, the right trousers component is premarked by a
gusset. If a gusset is not available, the line-up position is
marked with tape or with a felt pen at the working plate
or at the pick-up plate.
Folder, Fig. 7:
The folder 1 moves right to the pick-up plate 1 and
makes the working plate accessible. The cutter 3
opens, the two cutters 4 and 5 are passive and
remain concealed in the working plate.
Right trousers component line-up position, Fig. 8:
The right trousers component 4 is aligned with the
gusset at the cutter 2 and parallel to the pick-up plate
and the folder at the red marking 3 of the guide la-
ser 1.