Beisler 2211-5 - Manual (Page 94)

Short Seam Automat 2211-5 Working Instructions
- D 94 -
Beisler Automated Sewing Equipment
D.3
Programming
„ „ „ „ „ Switching the rest thread monitor on or off:
Depending on the specifications of the sewing head, the
machine is equipped with a rest thread monitor (for lock
stitch upper part). Monitor can be switched on or off for
testing purposes. To switch a monitor on or offf:
9
• Press  key
NOTE - Operation without thread monitor!
During normal production, the rest thread monitor or
the top thread monitor should always be switched on
as otherwise the sewing programm will not be stop-
ped if the thread breaks
„ „ „ „ „ Switching clamp position behind end of seam on
or off:
If this function is enabled, the closed clamp moves to the
clamp transport end point behind the end of the seam be-
fore releasing the sewing piece. To enable or disable this
function:
6
• Press  key.
„ „ „ „ „Moving clamp to waiting position:
If this function is enabled, the clamp moves to the waiting
position (e. g. special parameter 05: 48 cm).
V
• Press  key.
„ „ „ „ „ Scissors pick-up plate (left side pocket, right slash
selvage for ladies' trousers):
Enable scissors:
T
• Press  key.
D.3.12 Level 5 special parameters / Functions
Level 5 submenus
%QR96VT

F1 Back to level 4
F3 Switch top thread monitor on or off
F4 Switch bottom thread monitor for chain stitch upper
part on or off
F5 Switch rest thread monitor for lock stitch upper part
on or off
F6 Clamp position after end of seam
F7 Clamp waiting position
F8 Scissors pick-up plate left side pocket
„ „ „ „ „ Switching the top thread monitor on or off:
For testing purposes, the top thread monitor can be swit-
ched off. To switch the top thread monitor on or off:
Q
• Press  key.
NOTE - Operation without top thread monitor!
During normal production, the top thread monitor should
always be switched on as otherwise the sewing programm
will not be stopped if the thread breaks.
„ „ „ „ „ Switching the bottom thread monitor on or off:
Depending on the specifications of the sewing head, the
machine is equipped with a bottom thread monitor (for
chain stitch upper part). Monitor can be switched on or off
for testing purposes. To switch a monitor on or off:
R
• Press  key
NOTE - Operation without thread monitor!
During normal production, the rest thread monitor or
the top thread monitor should always be switched on
as otherwise the sewing programm will not be stop-
ped if the thread breaks.