Beisler 2211-5 - Manual (Page 77)

- D 77 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.1 System menu
„ „ „ „ „ Eprom seam parameters
This function allows to copy the factory-programmed fi-
xed seams from the Eprom back to the sewing program.
• Press W key.
• Press  key (init parameters).
• Press  key (Eprom seam parameters).
• Enter seam number 01 using numeric keypad.
„ „ „ „ „ Setting the seam sequence
The settings refer to the selected sewing program. The
sequence for sewing the seams can be set at will. When
the sequence is set, existing seam numbers are overwrit-
ten or new seam numbers are written.

• Press  key.
4
• Press  key.
The display shows the marking of the sewing program and
the seam numbers.
20 01 02 03 04
Mark seam number to be changed using cursor:
20 01 02 03 04
• Press $ key.
Enter new seam number using numeric keypad:
20 01 04 03 04
Confirm input and exit menu:
• Press W key.
The display shows the new seam sequence.
20 01 04 03 04
D.3.1 System menu
„ „ „ „ „ Copying seam numbers
Use this function to copy the properties of a factory-pro-
grammed sewing program or of your self-configured se-
wing programs into an other sewing program. During the
copying process, all seams of a sewing program are trans-
ferred so that the existing properties of a sewing program
will be overwritten completely..
1. Request sewing program (destination) and mark desi-
red seam number (source).
• Press  key.
2. Enter two-digit seam number using numeric keypad.
• Press W key.
• Press  key (init parameters).
• Press  key (copy seam number).
• Enter two-digit seam number using numeric keypad.
The display shows *O.K. PLEASE WAIT* to indicate that
the copy process has been successfully completed.
„ „ „ „ „ Erasing seams
Request sewing program and mark seam number to be
erased using cursor (seam number is underlaid black).
• Press . or Y key
• Press W key.
• Press  key (init parameters).
• Press  key (erase seam).
• Enter seam number using numeric keypad.
Confirm safety prompt, press $ key.
NOTE - Deleting seam numbers!
If a seam number is deleted, it is removed from all se-
wing programs into which it had been inserted.