Belshaw Adamatic Type B Donut Cutter - Manual (Page 19)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Type B Donut Cutter TS MN-1528EN 3
fryer from tipping if a column mounted cutter is
inadvertently swung out away from the fryer.
The extension limiting bracket is required for
models 618, 618L and 624 fryers. Refer to the
instruction sheet SB-91 in the Appendix.
C: Column Mounting on non-Belshaw
Fryer without Adapter Kit
1. Fasten the fryer to the floor.
2. Slide the column mounting brackets onto
the column.
3. Determine the column location by
standing the column with mounting
brackets against the fryer cabinet near the
back corner of the fryer on the side the
operator will stand. The mounting
brackets can be fastened to either the
back or the side of the cabinet, but be
sure the location you choose will allow
free movement of the swing arm,
4. After the location has been chose, use a
level to make the column assembly as
vertical as possible. For stability, locate
the two column mounting brackets as far
apart as possible.
5. Use the holes in the mounting brackets as
guides for drilling 5/16” holes in the fryer
cabinet. Secure the mounting brackets
and assembled column to the fryer
cabinet with 5/16” bolts, flat washers,
lock washers and nuts.
6. With the column resting on the floor,
tighten square head set screws in the
mounting brackets.
7. Slide the set collar onto the column.
8. Slide the straight arm section onto the
column. Connect the pivot arm to the
straight arm with the arm pin (See Figure
2).
IMPORTANT: A 618L-0104 extension
limiting bracket is designed to help keep the
fryer from tipping if a column mounted cutter is
inadvertently swung out away from the fryer.
The extension limiting bracket is required for
models 618, 618L and 624 fryers. Refer to the
instruction sheet SB-91 in the Appendix.
WARNING
When drilling holes through the fryer
cabinet, be sure the drill does not damage
the fryer internally.
9. The cutter frame can now be mounted on
the pin at the end of the pivot arm.