Belshaw Adamatic Type B Donut Cutter - Manual (Page 31)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Type B Donut Cutter TS MN-1528EN 15
TRIP ARM ADJUSTMENT ON “B” & “F” CUTTERS
If the machine gets jammed, the trip arms may go
out of adjustment. The following procedure
should be used to check and readjust the trip arms.
1. Set the dial to #3 (maximum).
2. Turn the cutter by hand until the lower trip
arm is at its lowest position.
3. Check dimension “A” (see illustration). If
necessary, bend the lower trip arm to
attain this dimension (11.063”).
4. Turn the cutter until the upper trip arm is
at its lowest position.
5. Check dimension “B” (see illustration). If
necessary, bend the upper trip arm to
attain this dimension (12.53”).
6. Turn the cutter until the dial pointer is
pointing straight down. Check dimension
“C.” Turn the cutter until the dial pointer
is pointing straight up. Check dimension
“D.” If either “C” or “D” is not correct,
parts may be worn and should be replaced.
SB-18