Beurer BM 35 - Manual (Page 77)

77
Electromagnetic Compatibility Information
Table 1
Guidance and manufacturer’s declaration – electromagnetic emissions
The BM 35 is intended for use in the electromagnetic environment specifi ed below. The customer or the user of the BM 35 should assure that it
is used in such an environment.
Emissions test Compliance Electromagnetic environment – guidance
RF emissions CISPR 11 Group 1 The BM 35 uses RF energy only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference in nearby electronic equip-
ment.
RF emissions CISPR 11 Class B The BM 35 is suitable for use in all establishments, including domestic establish-
ments and those directly connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Harmonic emissions IEC 61000-3-2 Not applicable
Voltage fl uctuations/fl icker emissions
IEC 61000-3-3 Not applicable
Table 2
Guidance and manufacturer’s declaration – electromagnetic immunity
The BM 35 is intended for use in the electromagnetic environment specifi ed below. The customer or the user of the BM 35 should assure that it
is used in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment – guidance
Electrostatic discharge (ESD)
IEC 61000-4-2 ± 6 kV contact
± 8 kV air ± 6 kV contact
± 8 kV air
Floors should be wood, concrete or ceramic tile. If fl oors are
covered with synthetic material, the relative humidity should be
at least 30 %.
Power frequency (50/60 Hz)
magnetic fi eld IEC 61000-4-8
3 A/m 3 A/m
Power frequency magnetic fi elds should be at levels charac-
teristic of a typical location in a typical commercial or hospital
environment.