Beurer MC 5000 - Manual (Page 27)

27
8. What if there are problems?
Problem Cause Solution
Grinding noises during
operation.
These noises are normal and originate from
the operating motor or from the massage
rollers rubbing against the cushion.
No action is necessary.
The massage cannot
be started.
The mains plug is not connected to
the socket.
> Plug the mains plug into the socket.
The massage chair is not switched on at
the main switch.
> Switch on the massage chair at the
main switch.
The cutout switch for the massage chair
has interrupted the power supply.
> In this case, please contact
Customer Service.
Back rest or leg rest
cannot be raised or
lowered.
Back rest and/or leg rest are overloaded
or blocked.
> Remove the objects blocking
the device.
The massage function
stops when the chair is
in operation.
The overheating protection was triggered. > Switch off the massage chair and
allow to cool down for 30 minutes
before switching on again.
The maximum operation period was
reached.
9. Technical Data
Product description Massage chair MC5000
Mains voltage/frequency 220-240 V ~ 50/60 Hz
Energy consumption 200 W
Dimensions (in flat position) Length 191 cm, width 73 cm, height 64 cm
Weight Net 61 kg, with packaging 76 kg
Maximum load capacity 200 kg
10. Disposal
Observe the local regulations for material disposal.
Dispose of the unit in accordance with EC Directive
2002/96/EC – WEEE (Waste Electrical and Electronic
Equipment).
If you have any questions, please contact
the local authorities responsible for waste
disposal.
11. Warranty and service
In the event of a warranty claim or service case,
please contact Customer Services in your respective
country.
You can find the address in the enclosed address list.