Beurer EM 35 - Manual (Page 14)

14
Avoiding unwanted pulse changes
To avoid inadvertently increasing the intensity of a training session, simply switch on the key lock.
Press the program selection key for around 3 seconds for this purpose (3). An acoustic signal
sounds and the “ ” symbol appears on the display. To deactivate the key lock press the key
once more.
Reacting to unpleasant sensations
If you feel prickling or itching on your skin even if, at this stage, you only notice a tingling and not
muscle contraction, you should switch off the device and proceed as follows:
– Check whether the electrodes are OK or if they are defective.
– Check whether the round cover over the electrode connections is still in place.
– Take the belt off and completely moisten it again.
– Ensure good skin contact and good moistening the next time the belt is applied.
Taking a break during the training session
If you wish to take a break during a program, briefly press the Pause key. An acoustic signal sounds
and the pause symbol “II” symbol appears on the display. By pressing the key again you can conti-
nue the program.
Reading off the number of training sessions
You can read off the number of your training sessions on the display. The numbers after the pro-
gram denote how often you have already fully completed a program. These numbers are stored until
there is a battery change.
6. Cleaning
– Remove the batteries from the device every time you clean.
– Clean the device with a slightly moistened cloth. In case of more
extreme soiling you can also moisten the cloth with mild soapy water.
– Never drop the device.
– Ensure that no water penetrates into the machine. If this should ever happen, only use the
machine again once it is completely dry.
– Do not use any chemical cleaners or abrasive agents for cleaning.
– Once you have removed the device (operating unit), you can clean the belt with a damp cloth. Use
mild soapy water or a liquid detergent for this purpose. Do not use bleaches.
– The belt is unsuitable for machine washing.
7. Technical Specifications:
Model: EM 35
Power supply: 3 x 1.5 V AAA (type LR 03)
Electrode size: approx. 11,3 x 6 cm: 7,8 x 9,7 cm
Parameter (500 Ohm load): – Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
Pulse duration: 200µs per phase
Waveform: symmetrical, dual-phase square wave
Weight: ~ 330 g
Belt size for waist measurement from 75 to approx. 140 cm.
Accessories:
belt extension 40 cm
Maximum permissible operating conditions: 0 °C to +40 °C, 20-65% relative humidity