Beurer BG 39 - Manual (Page 12)

12
5.3 Taking measurements
After all parameters have been entered, you can now measure your weight, body fat and the other data.
– Switch on the scale.
– Select the memory preset where your basic
personal data are stored by pressing the “up”
button repeatedly. These data are then shown
consecutively with the display of the ideal weight until the display “0.0” appears.
– Step on the scale with bare feet and stand still on the electrodes.
Important: There may be no contact between feet, legs, calves and thighs. Otherwise the measurement will
not be performed correctly.
note: Information on ideal weight only applies for persons over 18 years old
The following data are automatically displayed consecutively:
1. Weight and percentage of body fat
2. Weight and percentage of body water
3. Weight and percentage of muscle
4. Bone mass and active metabolic rate “kcal”.
Then your weight and the percentage of body fat are shown again until the display “0.0” appears. The scale
is now ready for another measurement (repeat measurement). If you do not carry out a measurement, the
scale switches off automatically after several seconds.
Your measured value is automatically stored during switch-off. Two memories are available for each user
for this purpose.
5.4 Displaying measured value memory
After selecting a memory and carrying out a determination of body fat, the display “0.0” appears briefly.
Pressing the “down” button displays your last stored measured value. The
weight, percentage of body fat, percentage of body water and muscle mass are
displayed consecutively. Pressing the “down” button again displays your se-
cond-to-the-last stored measured value.
6. evaluation of results
Body fat percentage
The following body fat percentages are for guidance (contact your physician for further information).
This diagnostic scale is equipped with an interpretation pyramid for simple classification of your body fat va-
lues. This shows you at a glance which category your percentage of body fat is classified in.