PSC Falcon 5500 - Manual (Page 16)

Configuration Settings
12
Falcon
®
5500 RFID Mobile Hybrid Computer
Configuration Examples
The following examples illustrate ways to optimize RFID settings for specific
situations.
Reading tagged items from an entire shelf
1. Press the trigger and move across the items on the shelf.
As new tags are found, the Falcon will beep and new data will immedi-
ately be sent to an application.
2. Continue passing over all the items until no beeps are heard, which is an
indication that all tags have been read.
Read a single tag while avoiding reading other tags
1. Place the RFID antenna close to the tag you wish to read and press the
trigger.
The initial low power level should limit the tags which receive RF energy
to those which are close to the Falcon. If the Falcon isn't close enough,
having
Growing Power enabled will allow the RF power to increase just
enough to read the nearest RFID tag in range.
2. Once the first tag is read, then the operation will stop.
Configuration Item Setting
Report Frequency 1 tag
Total Read Timeout Infinite
Minimum Tag Count Infinite
New Tag Timeout
Something longer than the time required to
move the RFID antenna over all of the tags (for
example 10 seconds)
Configuration Item Setting
Growing Power Enabled
Minimum Power Lowest setting
Minimum Tag Count 1 tag