ChamSys SnakeSys - Manual (Page 11)

SnakeSys User Manual 5 / 44
2.3 Art-Net Output + DMX Input
This mode is exactly the same as Art-Net Output except that the DMX Input connector on the rear of the unit is enabled, DIP
Switch 2 is used to enable the rear DMX Input.
The Input Art-Net Universe follows after the 4 Output Universes, so for example when the rotary encoders are set to 0-0 the 4
DMX Output Ports would map to Subnet 0, Universes 0, 1, 2, 3 and the DMX Input would generate Art-Net Universe 4.
The DMX Input LED will illuminate when the B4 is receiving DMX.
2.4 ACN Output
On the DMX output end of the B4, the DIP switches are used to configure the device mode. For ACN to DMX output mode DIP
Switch 3 should be up and all other DIP switches should be in the down position.
The rotary encoders on the reverse side of the unit are used to configure the ACN Universes. With the left hand encoder setting
the ten value and the right encoder setting the unit value.
In this mode universes following sequentially, so for example when set to 0-1 the 4 DMX output ports would map to ACN
Universes 1, 2, 3, 4 respectively. The LEDs next to the DMX output sockets will light in Blue when the DMX port is active and
the unit is outputing DMX.