ChamSys SnakeSys - Manual (Page 41)

SnakeSys User Manual 35 / 44
Menu Item Function
TX Packet MAB Used to adjust the length of the transmitted DMX Mark
After Break which is adjustable in microseconds
TX Retransmit Time When DMX network packets are not received this
corresponds to the frame refresh delay between transmitted
DMX packets to keep the DMX transmit alive, and is
adjustable in milliseconds.
Default This restores the DMX settings to factory default values.
This is a useful feature to try if you experience issues with
fixtures and are unsure what the DMX packet settings
should be.
5.5 RDM Support
The R8 hardware supports full RDM functionality, however RDM is not currently supported in R8 firmware.
5.6 ChamNet Mode Information
In ChamNet Mode the SnakeSys R8 is configured and controlled from the Net Manager within MagicQ.
Note
The main IP address for the Interface can be reconfigured in Net Manager. It is not possible to change the secondary IP
address from within Net Manager.
Note
The R8 unit will remember the settings that you make in MagicQ Net Manager. Please allow at least 40 seconds for the unit to
store the information into flash memory before removing the power. If the unit is left in MagicQ ChamNet mode it will boot up
with the settings that you made previously in Net Manager. (MagicQ will not be required to be connected via network to retain
the settings).
5.7 Powering the SnakeSys R8
SnakeSys R8 is powered using the supplied Powercon cable.
The power supply is universal wide range input type and has the following specification: 85 to 264VAC @ 47 to 63 Hz or 120
to 370VDC
The SnakeSys R8 does not have an internal battery.
Caution
During usage please ensure that the unit has adequate ventilation and that the cooling grilles on the unit are not
obstructed.
5.8 Security Measure Warning
The R8 incorporates a number of advanced security measures to prevent copying and unauthorized reproduction of the firmware.