Cloud Electronics CAM16 - Manual (Page 4)

CAM-16 / CAS-16 User Manual v1.0 4
Safety Information
Safety notes regarding installation
•
Do not expose this unit to water or moisture
•
Do not expose the unit to naked flames.
•
Do not block or restrict any air vent
•
Do not operate the unit in ambient temperatures above
45°C
•
The unit has no internal user adjustable parts. Do not
remove any panel.
•
Refer any servicing to qualified service personnel.
•
Do not replace the power transformer with any other
type
Conformities
The Cloud CAM-16 and CAS-16 conform to the following
European EMC Standards:
BS EN 55103-1:2009
BS EN 55103-2:2009
These products have been tested for normal use in
the commercial and light industrial environment. If the
equipment is used in controlled EMC environments, the
urban outdoors, heavy industrial environments or close
to railways, transmitters, overhead power lines etc., the
performance of the units may be degraded.
The Cloud CAM-16 and CAS-16 conform to the following
European electrical safety standard:
BS EN 60065:2002
The power transformers for the Cloud CAM-16 and
CAS-16 conform to the following standards:
Power transformer for the UK market:
BS EN60742 + BABT
Power transformer for the European market:
EN60742 + EN60950
Power transformer for USA and Canada:
C-UL Approved
Power supply information
The CAM-16 and CAS-16 are each shipped with a 15 V AC,
1.25 A transformer. When powering the CAM-16 and CAS-
16, please ensure that your local AC supply is within the
range of voltages required by the adaptor BEFORE you plug
it into the mains. We strongly recommend that you only use
the supplied transformer.
When the power switches are in the off (‘O’) position, the
CAM-16 and CAS-16 are disconnected from the power
transformers.
CAUTION – Servicing
The unit contains no user serviceable parts. Refer servicing
to qualified service personnel. Do not perform servicing
unless you are qualified to do so. Disconnect the power
cable from the unit before removing the top or bottom
panel. Only reassemble the unit using bolts/screws identical
to the original parts.