Cloud Electronics CX261 - Manual (Page 4)

CX261 User Manual v1.3 4
Safety Information
Safety Notes Regarding Installation
•
Do not expose the unit to water or moisture.
•
Do not expose the unit to naked flames.
•
Do not block or restrict any air vent.
•
Do not operate the unit in ambient temperatures above
35 °C.
•
Do not touch any part or terminal carrying the
hazardous live symbol ( ) while power is supplied to
the unit.
•
Do not perform any internal adjustments unless you
are qualified to do so and fully understand the hazards
associated with mains-operated equipment.
•
The unit has no user-serviceable parts. Refer servicing
to qualified service personnel.
•
If the moulded plug is cut off the AC power lead for
any reason, the discarded plug is a potential hazard and
should be disposed of in a responsible manner.
Conformities
This product conforms to the following European EMC
Standards:
BS EN 55103-1:1997
BS EN 55103-2:1997
This product has been tested for use in commercial and
light industrial environments. If the unit is used in controlled
EMC environments, the urban outdoors, heavy industrial
environments or close to railways, transmitters, overhead
power lines, etc., the performance of the unit may be
degraded.
The product conforms to the following European electrical
safety standard:
BS EN 60065:2002
The CX range was developed and manufactured with high
quality materials and components, which can be recycled
and/or reused.
Safety Considerations and Information
The unit must be earthed. Ensure that the mains power
supply provides an effective earth connection using a three-
wire termination.
Caution - High Voltages
Do not touch any part or terminal carrying the hazardous
live symbol ( ) while power is supplied to the unit.
Terminals to which the hazardous live symbol refers require
installation by a qualified person.
Caution - Mains Fuse
Replace the mains fuse only with the same type and rating as
marked on the rear panel.
The fuse body size is 20 mm x 5 mm.
Caution - Servicing
The unit contains no user-serviceable parts. Refer servicing
to qualified service personnel. Do not perform servicing
unless you are qualified to do so.
Disconnect the power cable from the unit before removing
the top panel and do not make any internal adjustments with
the unit powered on.
Only reassemble the unit using bolts/screws identical to the
original parts.