Code Blue CB 2-E ECONOMICAL WALL MOUNT HELP POINT - Manual (Page 25)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-149-G page 25 of 43
CB 2 Series
Administrator Guide
15 CB 2-s Installation Instructions
1.0 PRE-INSTALLATION
1.1 Running the wires – Wires to the unit may be run either (a) from behind the unit through
the wall, or (b) from below the unit using an external conduit through the bottom of the unit’s
back plate. Holes in the back and bottom of the unit have been provided for this purpose.
2.0 INSTALLATION PROCEDURES
2.1 Remove the light bracket and outer shell from the back plate.
2.2 Mark the mounting holes – In order to comply with the Americans with Disabilities Act
(ADA) of 1990, the speakerphone button(s) should be positioned between 34 and 48 inches
from grade level. (Consult an ADA specialist in your area to verify local and federal guide-
lines.)
2.3 Install the back plate – Four anchors should securely fasten the back plate to the wall.
IMPORTANT: If wiring is coming in from the back, ensure that the conduit is aligned at this
time.
2.4 Reattach the light bracket.
2.5 Reattach the outer shell – Holding the shell horizontal, hook the bottom hinge into the bot-
tom of the back plate. Swing the shell up and fasten the safety cable to the eyehook.
2.6 Connect electrical and communications wiring (see wiring instructions).
2.7 Close the unit – Fasten the outer shell to the back plate using two #10 countersunk secu-
rity screws.
See diagrams next page