Comtech EF Data C5 - Manual (Page 294)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–10 Rev. 0
Interface Loop-
back Command:
Response:
Status:
Response:
<add/ILB_xxx'cr'
>add/ILB_xxx'cr''lf']
<add/ILB_'cr'
>add/ILB_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface Loop
Timing Command:
Response:
Status:
Response:
<add/ILT_xxx'cr'
>add/ILT_xxx'cr''lf']
<add/ILT_'cr'
>add/ILT_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface Buffer
Size Buffer size programming is supported in two
formats; bits, or milliseconds. The selected format
must be chosen using the buffer programming
command (IBP_). If the buffer is to be programmed
in milliseconds and plesiochronous slips are
required use the receive framing structure
command (IRFS_) to define the proper framing
format.
Note: For Drop & Insert: Only milliseconds format is
allowed.
Interface Buffer
Size (Bit Format) Command:
Response:
Status:
Response:
<add/IBS_nnnnnn'cr'
>add/IBS_nnnnnn'cr''lf']
<add/IBS_'cr'
>add/IBS_nnnnnn'cr''lf']
Where: nnnnnn = 32 to 262144 in 16 bit
increments.
Interface Buffer
Size
(Millisecond
Format) Command:
Response:
Status:
Response:
<add/IBS_nn'cr'
>add/IBS_nn'cr''lf']
<add/IBS_'cr'
>add/IBS_nn'cr''lf']
Where: nn = 0 to 99 (buffer size in milliseconds).
Interface Buffer
Center Command:
Response: <add/IBC_'cr'
>add/IBC_'cr''lf']
Interface Buffer
Programming Command:
Response:
Status:
Response:
<add/IBP_xxxx'cr'
>add/IBP_xxxx'cr''lf']
<add/IBP_'cr'
>add/IBP_xxxx'cr''lf']
Where: xxxx = BITS or MS (milliseconds).
Note: For Drop & Insert: Only milliseconds format is
allowed.
Interface
Receive Framing
Structure Command:
Response:
Status:
Response:
<add/IRFS_ff_ssss'cr'
>add/IRFS_ff_ssss'cr''lf']
<add/IRFS_ff'cr'
>add/IRFS_ff_ssss'cr''lf']
Where:
ff = T1 or E1 (frame type).
ssss = NONE or G704 (framing structure).
Interface
Substitute
Pattern
(Transmit 2047
Pattern) Command:
Response:
Status:
Response:
<add/ISP_xxx'cr'
>add/ISP_xxx'cr''lf']
<add/ISP_'cr'
>add/ISP_xxx'cr''lf']
Where: xxx = ON or OFF.
Interface Read
Error Select
(Receive 2047
Pattern) Command:
Response:
Status:
Response:
<add/IRE_xxx'cr'
>add/IRE_xxx'cr''lf']
<add/IRE_'cr'
>add/IRE_xxx'cr''lf']
Where: xxx = ON or OFF.