Comtech EF Data C5 - Manual (Page 324)

Remote Control Operation C5/K1/K3 Integrated Satellite Terminal System
B–40 Rev. 0
Built In Self
Test Command:
Response:
Response:
Status:
Response:
<add/BIST_xxxx'cr'
for (OFF):
>add/BIST_xxx'cr''lf']
for (RUN):
>add/BIST_xxx'cr'
ST_xxx'cr''lf']
<add/BIST_xxx'cr'
>add/BIST_xxx'cr''lf']
Where: xxx = OFF (self test disabled), RUN (run self test
now).
Self Test (OK/FLT)
Note: Allow 35 Seconds for response to RUN the Self
Test.
LCP Data
Bits
Command Command:
Response: <add/DAT8_dddd'cr'
>add/DAT8_z'cr''lf'] Where:
Dddd = duct Device Number: ASCII hexadecimal
values representing the device number to erase.
These values should be copied directly from the <DN>
field from the initialization file. This is ignored for
multiple paged memory schemes, but needed for
single paged schemes.
Z= Status: One byte binary value (0x00 - 0xFF)
pertaining to the execution of the previous command.
Valid status values returned: LCP_FAILURE,
LCP_SUCCESS.
Each letter represents 1 byte.
State Of
Product Command:
Response: <add/SOP_'cr'
>add/SOP_'cr'
add'cr'
abc'cr'
rrrrr bps'cr'
<var-string1>'cr'
<var-string2>'cr''lf']
Product Address
Data format
Baud Rate
Comm Type
abc = Explained below.
a = Number of data bits ( 7 )
b = Parity type (O, E, N)
c = Number of stop bits (1)
rrrr = baud rate ('150', '300', '600', ' 200', '2400', '4800',
'9600', '14.4K', '19.2K').
<var-string1> = Variable length strings explaining
communication hardware type 'RS-485, 2 wire', 'RS-485,
4 wire' 'RS-232'.
<var_string2> = Variable length strings explaining the
intention of the product. 'Under normal system operation',
'REFLASH of BULK firmware required', 'REFLASH of
M&C firmware required'.