Document Outline

• CMR-6000 Rev 1
• Errata A Tuner Menu
• Errata B Appendix F
• Errata C DVB-S2 Pilot Command
• Table of Contents
• Preface
  • Customer Support
  • About this Manual
    • Reporting Comments or Suggestions Concerning this Manual
  • Conventions and References
    • Cautions and Warnings
    • Metric Conversion
    • Recommended Standard Designations
    • Trademarks
  • Electromagnetic Compatibility (EMC) Compliance
    • Emissions Compliance
    • EN61000 Compliance
  • Safety Compliance
    • EN60950 Compliance
    • Low Voltage Directive (LVD)
  • Warranty Policy
    • Limitations of Warranty
    • Exclusive Remedies
• CMR6000-Ch1_Introduction
  • 1.1 Standard Features
  • 1.2 Performance
  • 1.3 Configurations
  • 1.4 Specifications
  • 1.5 Acronym Definitions
• CMR6000-Ch2_Installation
  • 2.1 Major Assembly
  • 2.2 Unpacking
  • 2.3 Installation
  • 2.4 Initial Configuration
  • 2.5 Connect External Cables
• CMR6000-Ch3_Pinouts
  • Chapter 3. INTERFACE PINOUTS
    • 3.1 Pinout Overview
    • 3.2 RJ-45 Ethernet
    • 3.3 RJ-12 Redundancy
    • 3.4 RJ-12 Terminal
    • 3.5 ASI (RX and TX)
    • 3.6 F-Type L-Band
• CMR6000-Ch4_UserInterface
  • 4.1 Introduction
  • 4.2 Web Interface
    • 4.2.1 Administrative Configuration
    • 4.2.2 SNMP Configuration
    • 4.2.3 Vload Configuration
    • 4.2.4 Syslog Configuration
    • 4.2.5 Redundancy Configuration
    • 4.2.6 Network Configuration
    • 4.2.7 Network ARP
    • 4.2.8 Egress
    • 4.2.9 IGMP Configuration
    • 4.2.10 Unicast Routing Configuration
    • 4.2.11 MPE/IP Configuration
    • 4.2.12 Tuner MPEG TS Route Configuration
    • 4.2.13 Service Filter Route Configuration
    • 4.2.14 Tuner Configuration
    • 4.2.15 Route Statistics
    • 4.2.16 Tuner Statistics
  • 4.3 Front Panel Interface
    • 4.3.1 LED Status Lights
    • 4.3.2 Keypad
    • 4.3.3 LED Menu Display
    • 4.3.4 FAST
  • 4.4 Terminal Interface
    • 4.4.1 Login
    • 4.4.2 Main Menu
    • 4.4.3 Redundancy Menu
    • 4.4.4 Administration Menu
    • 4.4.5 ASI Configuration Menu
    • 4.4.6 IGMP Configuration Menu
    • 4.4.7 Egress Configuration Menu
    • 4.4.8 Stats Menu
    • 4.4.9 Network Configuration Menu
    • 4.4.10 Unicast Routing Configuration Menu
    • 4.4.11 Tuner Menu
  • 4.5 Telnet Interface
  • 4.6 Trivial File Transfer Protocol (TFTP)
  • 4.7 Simple Network Management Protocol (SNMP)
    • 4.7.1 SNMP Traps
• CMR6000-Append_A_SWUpgrade
  • Appendix A. SOFTWARE UPGRADE
    • A.1 Introduction
    • A.2 Web Interface
    • A.3 Telnet or Terminal Interface
• CMR6000-Append_B_IPRouteSupport
  • Appendix B. 0BIP ROUTING SUPPORT
    • B.1 1BIntroduction
    • B.2 2BIP Configuration
      • B.2.1 4BUnicast Routing
      • B.2.2 5BMulticast Routing
    • B.3 3BSection Packing
• CMR6000-Append_C_SysLog
  • Appendix C. SYSTEM LOG CONFIGURATION
    • C.1 Introduction
    • C.2 Enabling a System Logger
• CMR6000-Append_D_SatelliteReceiverSetup
  • Appendix D. SETTING UP A DIGICAST DIGITAL SATELLITE RECEIVER
    • D.1 Introduction
    • D.2 Required Information for Setting Up a Digicast Satellite Receiver
    • D.3 Verify Frequency Values
    • D.4 Configure the Equipment
    • D.5 Important Terms to Understand
• CMR6000-Append_E_SNMPConfiguration
  • Appendix E. Configuring and Controlling the Digicast CMR6000 Media Router with SNMP
    • E.1 Required SNMP Information for Configuring a Digicast Product
    • E.2 Configuring the Digicast CMR6000 Product for SNMP
    • E.3 SNMP and Digicast Products
    • E.4 MIB II
      • E.4.1 MIB II OIDs on the Digicast Media Router (Model CMR6000)
    • E.5 Private MIB
      • E.5.1 Private MIB OIDs on Digicast Products
    • E.6 Important Terms to Know
• CMR6000-Append_F_DVBSS2 BER Performance QEF
  • Appendix F. DVB-S/S2 BER Performance at Quasi-Error Free (QEF)