Comtech EF Data MDX420 SkyWire Manual - Manual (Page 93)

MDX420 SkyWire™ Satellite Network Gateway SkyWire Controller (GUI)
MN-MDX420 Revision 6 7–37
Figure 7.7.1 SNMP Version 3 Terminal Screen
USER1 USER2 USER3 USER4
ID administrator operator viewer
Group ADMIN OPER VIEWER NO GROUP
AuthP password password password
PrivP password password password
AuthM MD5 MD5 MD5 NONE
PrivM DES DES DES NONE
User Reset
Table 7.7.1 SNMP Version 3 Terminal Default Parameters
Administrator Settings for SNMP Terminal Screens:
ID 1-4: Default names are administrator, operator and viewer. Names can change.
Group: ADMIN, OPER, OR VIEWER
AuthP: Defined by the administrator and at least 8 characters in length.
PrivP: Defined by the administrator and at least 8 characters in length.
AuthM: None, MD5 or SHA
PrivM: None, DES
Reset: Resets the user parameters to the defaulted names listed
Note: Parameters assigned in the Terminal must be the parameters used when logging in with
the SkyWire Controller.